精品熟女60老妇av免,欧美午夜,中文字幕无码一区二区三区亚洲,女人av天堂

What needs to be prepared before the operation of the pipe winch?

Release time:

2021-07-16

Pipe winch in the use of the process can better play its use effect, product use, should check the lubrication of the rotating part of the machine, to ensure that in the use of the process can better play a role, while in the use of the process has a good reliability. The balance of the product should be considered during operation.

What needs to be prepared before the operation of the pipe winch?

pipe winchWhat needs to be prepared before operation?

The pipe winch can better exert its use effect during use. When the product is used, the lubrication of the rotating part of the machine should be checked to ensure that it can play a better role during use, and at the same time, it is very good during use. reliability. The balance of the product should be considered during operation.

After all parts of the winch are checked properly, the personnel should leave to protect and prevent accidents. So in the process of operation, its speed is very low, there will be no noise. If there is any abnormality during operation, it can be stopped in time. When operating in the production process, the operator should not wear gloves to prevent some accidents.

During the service life of the pipe winch, labor protection articles shall be worn, production tools shall be prepared, and materials shall be collected in accordance with the production tasks and process procedures to ensure that the materials are qualified. At the same time, the machine and the machine should be inspected before use. In the case of rotation, lubricating oil should be added to different parts of each rotating gear. In order to better ensure its lubrication effect, at the same time, press the excitation switch to idling before working, and determine the direction of the ketone body according to the process.

Inpipe winchIt can be used normally during operation and installed according to process requirements. Well, the pitch wheel is selected, and the split film is installed in the grinding frame. The second is to open the protective cover, pull the spring pin on the side, and take out the wires from the basket respectively. And there is a brake pin on one side of the bracket, so during use, adjust the tension of the full reel according to the wire diameter.

The above information about what the operators need to prepare before the production of the tube winch is shared here. Through the above information, do you have more understanding of this product?